Star InactiveStar InactiveStar InactiveStar InactiveStar Inactive
The other week I was putting a sight glass back in a tank when I managed to overtighten one of the bolts and snap it off. I didn't really need to tighten up those bolts that much so it really shouldn't have happened. But accidents happen.
You can see what's left of the bolt snapped off in the bottom right of the fitting.

We came back to this problem over the weekend and fixed it. But fist I had to use a hammer.
Not a particularly heavy one, but big enough to make me nervous about breaking the removal tool which would have been next level bad.
Thankfully this part went well. Once the tool got in far enough to get a good bite it spun the bolt and the whole shebang came out. Then I had to get the bolt off the end of the removal tool. Awkward, but much less stressful than getting the bolt out.
And here is everything buttoned up and no longer holding up progress.

I had a bit of a play with the oil burner as well so keep an eye out for updates on that through the week.


Comments powered by CComment